User`s guide

GETTING STARTED
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
7
t
Installing the Card
The ConnectUPS-MS Card can be installed in any Eaton UPS equipped with a
communication bay without turning off the UPS or disconnecting the load.
To install the ConnectUPS-MS Card:
1. Remove the communication bay cover from the UPS. Retain the screws.
2. If not already done, record the card's MAC address for future reference (see
“Installation Checklist” on page 4).
3. To prevent electrostatic discharge (ESD), place one hand on a metal surface.
4. Slide the card into the open slot and secure with the screws removed in Step 1
(see Figure 4).
Figure 4. Installing the Card