Installation manual

34003905EN/AG
The Network Management Card can be hot-plugged on all
UPSs compatible with the card. It is not necessary to shutdown the
UPS, disconnect the load or restart the UPS.
z Remove the plastic cover of the Minislot.
z Note the MAC address of the card before inserting it.
z Insert and secure the card with the screws.
z Connect the ETHERNET cable.
z Check the ETHERNET port indications.
z Wait until the UPS Data LED flashes regularly (approx. two
minutes), indicating that card start-up has terminated correctly.
Nota : You can set the parameters via Service port even if the
network is not connected. At connection, the card will restart
keeping the settings.
Once the card has started, proceed as indicated below.
z Connect the serial cable to card’s service port and PC’s COM
port
z Use a terminal emulator such as HyperTerminal
TM
with these
settings
"Echo typed characters locally" option: disabled
z Type admin.
The main configuration menu is displayed:
The card is configured by default with this service enabled. No manual
configuration is required.The IP parameters are automatically collected
by the card.
From the main configuration menu: (see above)
z Press the 2 key (Network configuration).
z Press the 1 key(Read Network settings).
The settings supplied by the server are displayed:
z Note the IP address.
z Press the 0 key (Exit).
z Press the 0 key (Exit).
You can also use Intelligent Power Manager software utility to
view the card IP adress
The tool is available at download.eaton.com. It must be installed on a
network connected PC.
Manual configuration is required.
To set the network configuration, use terminal emulation (see
above)
From the main configuration menu:
z Press the 2 key (Network configuration).
z Press the 2 key (Modify Network settings).
z Follow the instructions and enter the IP parameters:
Wait until "Done" is displayed, indicating that the IP parameters have
been saved.
z Press the 0 key (Exit).
z Press the 1 key (Reset).
z Press the 2 key (Restart).
The card restarts with the new IP settings (after approx. one minute).
To check whether the
Network Management Card is
operational after installation and IP settings, proceed as follows.
z Run a browser
z Enter in the address bar:
http://IP address/ (e.g. http://166.99.1.82/)
z The home page is displayed
z Set the time by clicking the Time command.
z Continue configuration via the sections in the Settings menu.
INSTALLATION
IP SETTINGS
Bits per second Data bits Stop bits Parity Flow
control
9600 8 1 none none
EATON
NETWORK MANAGEMENT CARD
1 : Reset
2 : Network configuration
3 : Set Login Password to Default
4 : Return to Default Configuration
0 : Exit
Your network is equipped with a BOOTP/DHCP server
(default)
Network configuration :
MAC address : 00:20:85:FD:1C:07
Mode : DHCP
IP address : 166.99.23.18
Subnet mask : 255.255.248.0
Gateway : 166.99.17
Your network is not equipped with a BOOTP/DHCP server
1 : Read Network settings
2 : Modify Network settings
3 : Set ethernet speed
0 : Exit
For each of the following questions, you can press "Return" to
select
the value shown in braces, or you can enter a new value
Should this target obtain IP settings from the network?[N] N
Static IP address [192.168.1.2]?166.99.1.82
Subnet mask IP address [255.255.0.0]? 255.255.255.0
Gateway address IP address [0.0.0.0]? 166.99.17.1
Done
ACCESS TO SUPERVISION