User`s guide

Using the Telnet/SSH/CLI Interface
Eaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 61
Enviroment Commands
Use environment commands to define settings for environmental sensors (see Table 21).
Table 21. Environment Commands
getEnv To read an environment setting
Syntax getEnv [option1]
Options Name
Example #> getEnv Name
setEnv To modify an environment setting
Syntax setEnv [option1]
Options Name = “xx..xx”
Example #> setEnv Name=”sensor”
getTemp To read a temperature setting
Syntax getTemp [option1] [option2] ...
Options Unit
HighThreshold
LowThreshold
Hysteresis
Offset
HighNotify
LowNotify
HighShutdown
LowShutdown
Example #> getTemp Unit
setTemp To modify a temperature setting
Syntax setTemp [option1] [option2] ...
Options Unit = C|K
HighThreshold = xx
LowThreshold = xx
Hysteresis = xx (0..5)
Offset = xx (-5..5)
HighNotify = 0|1 (0=No, 1=Yes)
LowNotify = 0|1 (0=No, 1=Yes)
HighShutdown = 0|1 (0=No, 1=Yes)(NOTE 1)
LowShutdown = 0|1 (0=No, 1=Yes) (NOTE 1)
Example #> setTemp Unit=C
Comments (NOTE 1) : Writing enabled only if the notification is enabled
getHum To read a humidity setting
Syntax getHum [option1] [option2] ...
Options HighThreshold
LowThreshold
Hysteresis
Offset
HighNotify
LowNotify
HighShutdown
LowShutdown