User`s guide

Using the Telnet/SSH/CLI Interface
Eaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 60
Access Control Commands
Use access control commands to configure secure access to the card (see Table 19).
Date and Time Commands
Use date and time commands to set the date and time parameters for the card (see Table 20).
Table 19. Access Control Commands
getAccess
Syntax getAccess [option1] [option2] . . .
Options Login | Password | Security
Example #> getAcess Login
Comments For Password, each character is replaced with an asterisk (*).
setAccess
Syntax setAccess [option1] [option2] . . .
Options Login = “xx..xx“
Password = “**..**“(See Note 1)
Security = 1 | 2 | 3(1=configuration pages, 2=full authorization, 3=full authorization and SSL)
Example #> setAccess Security=3
Comments Note 1: Remember to set echo off.
getTelnet
Syntax getTelnet [option1] [option2] . . .
Options Access | Security | Console
Example #> getTelnet Security
setTelnet
Syntax setTelnet [option1] [option2] . . .
Options Access = 0 | 1(0=Disabled, 1=Enabled)
Security = 0 | 1(0=No, 1=Yes with SSH)
Console = CLI | Menu
Example #> setTelnet Security=0
Table 20. Date and Time Commands
getDate
Syntax getDate [option1] [option2] . . .
Options Date | Time | TimeSync | TimeNtp | TimeZone | TimeDaylight
Example #> getDate timeSync
setDate
Syntax setDate [option1] [option2] . . .
Options Date = yyyy/mm/dd(See Note 1)
Time = hh:mm:ss(See Note 1)
TimeSync = MANUAL | AUTO | NTP
TimeNtp = “xx..xx“
TimeZone = +/-hh:mm(See Note 2)
TimeDaylight = 0 | 1(0=No, 1=Yes)
Example #> getDate timeSync=MANUAL
Comments Note 1: Setting is write-enabled depending on “TimeSync“ status.
Note 2: Setting resolves to the nearest half hour. For example, sending +02:36 results in +02:30, and
sending +02:46 results in +03:00.