User`s guide

Using the Telnet/SSH/CLI Interface
Eaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 55
General Commands
Use general commands to open, close, and control sessions (see Table 14).
Network Commands
Use network commands to administer network parameters and authorizations (see Table 15).
Table 14. General CLI Interface Commands
help or ? Display help about a specific command.
Syntax help [command] or [command] ?
Example #> help getNetwork or #> getNetwork ?
setEcho Hide, or not, all characters. If hidden, each character entered is replaced by an asterisk (*).
Syntax setEcho [option]
Options ON | OFF
Example #> setEcho ON
quit Close a current CLI session.
Syntax quit
Example #> quit
reset Reset the software.
Syntax reset
Example #>
version Get information about the sotware version.
Syntax version
Example #> version
defaultPass Return to the default login and password.
Syntax defaultPass
Example #> defaultPass
defaultConf Return to the default configuration.
Syntax defaultConf
Example #> defaultConf
Table 15. Network Commands
getNetwork Read a network setting.
Syntax getNetwork [option1] [option2] . . .
Options DHCP | IPAddress | IPMask | IPGateway | HostName | DomainName | IPv6Enable | IPv6AutoConf |
IPv6Address1 | PrefixLength | IPv6DefaultGateway | IPv6LocalAddress | IPv6Address2 | PrimaryDNS |
SecondaryDNS | FirmwareUpgrade
Example #> getNetwork IPAddress