User`s guide

Configuring the Card
Eaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 25
Positive DC bus too high Positive DC bus OK
Negative DC bus too low Negative DC bus OK
Positive DC bus too low Positive DC bus OK
Inverter limitation Inverter end of limitation
Inverter fuses blown Input fuses OK
Inverter fault Inverter OK
Inverter overload Inverter load OK
Inverter over temperature Inverter temperature OK
Inverter short circuit Inverter OK
Inverter thermal overload Inverter load OK
Load not protected  On Automatic Bypass Load protected  Return from Bypass
Load short circuit Load OK
Load not powered Load powered
Protection Lost Protection OK
Emergency button ON Emergency button OFF
Fan fault Fan OK
Redundancy Lost Redundancy OK
Low battery Battery OK
UPS communication failed UPS communication restored
UPS data base not available UPS data base OK
UPS on battery UPS on normal AC
UPS internal fault UPS OK
UPS overload UPS returns to normal load
UPS overtemperature UPS temperature OK
Imminent UPS shutoff UPS OK
<Sensor name>:
Temperature is above high threshold xx°C
<Sensor name>:
Temperature is below high threshold xx°C
<Sensor name>:
Humidity is above high threshold xx %
<Sensor name>:
Humidity is below high threshold xx %
<Sensor name>:
Temperature is below low threshold xx°C
<Sensor name>:
Temperature is above low threshold xx°C
<Sensor name>:
Humidity is below low threshold xx %
<Sensor name>:
Humidity is above low threshold xx %
<Sensor name>:
<Input #1 label> <when closed label>
<Sensor name>:
<Input #1 label> <when closed label>
<Sensor name>:
<Input #1 label> <when open label>
<Sensor name>:
<Input #1 label> <when open label>
<Sensor name>:
<Input #2 label> <when closed label>
<Sensor name>:
<Input #2 label> <when closed label>
<Sensor name>:
<Input #2 label> <when opem label>
<Sensor name>:
<Input #2 label> <when open label>
Table 9. UPS Alarms
Alarm On Alarm Off