Technical data

June 2008
CA08102001E For more information visit: www.eaton.com
40-217
Adjustable Frequency Drives
40
CFX9000
Enclosed Drives
Technical Data and Specifications
Table 40-318. Specifications

The EMI filter is optional in FR10.

See Table 40-321 for specific ratings.
Table 40-319. Standard I/O Specifications
Feature Description CFX9000 Enclosed Products —
UL Type 1, UL Type 12, UL Type
3R and NEMA 12 Filtered
Primary Design Features
45 – 66 Hz Input Frequency Standard
Output: AC Volts Maximum Input Voltage Base
Output Frequency Range: Hz 0 – 320
Initial Output Current (I
H
) 250% for 2 seconds
Overload: 1 Minute (I
H
/I
L
) 150%/110%
Enclosure Space Heater Optional
Oversize Enclosure Standard
Output Contactor Optional
Bypass Motor Starter Optional
Listings UL, cUL
Protection Features
Incoming Line Fuses Optional
AC Input Circuit Disconnect Optional
Phase Rotation Insensitive Standard
EMI Filter FR6 – FR9

Input Phase Loss Protection Standard
Input Overvoltage Protection Standard
Line Surge Protection Standard
Output Short Circuit Protection Standard
Output Ground Fault Protection Standard
Output Phase Protection Standard
Overtemperature Protection Standard
DC Overvoltage Protection Standard
Drive Overload Protection Standard
Motor Overload Protection Standard
Programmer Software Optional
Local/Remote Keypad Standard
Keypad Lockout Standard
Fault Alarm Output Standard
Built-In Diagnostics Standard
MOV Optional
Input/Output Interface Features
Setup Adjustment Provisions:
Remote Keypad/Display
Personal Computer
Standard
Standard
Operator Control Provisions:
Drive Mounted Keypad/Display
Remote Keypad/Display
Conventional Control Elements
Serial Communications
115V AC Control Circuit
Standard
Standard
Standard
Optional
Optional
Speed Setting Inputs:
Keypad
0 – 10V DC Potentiometer/Voltage Signal
4 – 20 mA Isolated
4 – 20 mA Differential
3 – 15 psig
Standard
Standard
Configurable
Configurable
Optional
Analog Outputs:
Speed/Frequency
Torque/Load/Current
Motor Voltage
Kilowatts
0 – 10V DC Signals
4 – 20 mA DC Signals
Isolated Signals
Standard
Programmable
Programmable
Programmable
Configurable w/Jumpers
Standard
Optional
Feature Description CFX9000 Enclosed Products —
UL Type 1, UL Type 12, UL Type
3R and NEMA 12 Filtered
Input/Output Interface Features (Continued)
Discrete Outputs:
Fault Alarm
Drive Running
Drive at Set Speed
Optional Parameters
Dry Contacts
Open Collector Outputs
Additional Discrete Outputs
Standard
Standard
Programmable
14
2 Relays Form C
1
Optional
Communications:
RS-232
RS-422/485
DeviceNet™
Modbus RTU
CanOpen (Slave)
Profibus-DP
Lonworks
®
Johnson Controls Metasys™ N2
Ethernet IP
BACnet
Standard
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Performance Features
Sensorless Vector Control Standard
Volts/Hertz Control Standard
IR and Slip Compensation Standard
Electronic Reversing Standard
Dynamic Braking Optional
DC Braking Standard
PID Setpoint Controller Programmable
Critical Speed Lockout Standard
Current (Torque) Limit Standard
Adjustable Acceleration/Deceleration Standard
Linear or S Curve Accel/Decel Standard
Jog at Preset Speed
Standard
Thread/Preset Speeds 7
Automatic Restart Selectable
Coasting Motor Start Standard
Coast or Ramp Stop Selection Standard
Elapsed Time Meter
Optional
Standard Conditions for Application and Service
Maximum Operating Ambient
Temperature
0 – 50°C

Storage Temperature -40 – 60°C
Humidity (Maximum),
Non-condensing
95%
Altitude 100% load capacity (no derating) up
to 3280 ft. (1000m); 1% derating for
each 328 ft. (100m) above 3280 ft.
(1000m); max. 9842 ft. (3000m)
Line Voltage Variation +10/-15%
Line Frequency Variation 45 – 66 Hz
Efficiency >96%
Power Factor (Displacement) .99
Description Specification
6 – Digital Input Programmable 24V: “0” ≤ 10V, “1” ≥ 18V,R
i
> 5 k
2 – Analog Input Configurable
w/Jumpers
Voltage: 0 – ±10V, R
i
> 200 k
Current: 0 (4) – 20 mA, R
i
= 250 k
2 – Digital Output Programmable Form C Relays 250V AC 2 Amp or
30V DC2 Amp resistive
1 – Digital Output Programmable Open collector 48V DC 50 mA
1 – Analog Output Programmable
Configurable w/Jumper
0 – 20 mA, impedance 500 ohms,
resolution 106 ±3%