Specifications

Designed to meet the most stringent Life Safety requirements, Eaton’s HPSA-7100-R Series provides
highly intelligible voice and tone announcements for Wide-Area Mass Notification. The HPSA-7100-R
Series can be integrated with voice-capable Fire Alarm Control Panels (FACP) and SAFEPATH Systems.
External Interface
NAC input PTT Activation. 9–40 VDC, 17 mA Max.
Dry contact input PTT Activation (alternative to NAC Input). 250ms < 1 K Ohms.
Audio input 100 V
RMS
, 70.7 V
RMS
, 25 V
RMS
or 1 V
RMS
selectable (100 V
RMS
and 70.7 V
RMS
require model HPSA-7100-V-KIT, which is sold separately)
Trouble outputs Form C, dry contact. 2 Amps., 30VDC (resistive). Max. Trouble Signals (6) provided: AC, No Battery, Low Battery, Tamper, Amplifier
Fault and Driver Fault.
General Specifications
Electronic cabinet dimensions 36” W x 48” H (60” with pedestals) x 12” D / 91.4 x 121.9 (152.4 with pedestals) x 30.5 cm
Electronic cabinet weight 110 lbs (not including batteries) / 49.9 kg; Total weight with batteries: 322 lbs / 146 kg
Horn dimensions 3’ 2” W x 2’ 1” H x 1’ 4 7/16” D / 96.52 cm x 63.5 cm x 41.91 cm (2 horns with drivers, omni-directional)
Horn weight 52 lbs for each horn and driver kit (pair) / 23.6 kg
Horn material Special aluminum alloy horn construction provides long service life without material fatigue
Battery weight 53 lbs each / 24 kg
Speaker mounting/pipe pole
a
Minimum 4.5” (11 cm) outside diameter (OD); Maximum 6” OD (15.25 cm)
Ground mount pedestal kit
a
Model M37-00056 raises the cabinet 12” (30.5) cm) from the ground
Speaker cable kit
a
Model CAB-SPKR-KIT, 500 ft (152 m) long; 16 AWG stranded, non-shielded, marine-rated
Speaker wire
a
12–16 AWG stranded two-conductor jacketed cable. Non-shielded either twisted or non-twisted.
UL/CSA/EU: approved for outdoor use
Wire size ratings Speaker Lines: 12–16 AWG (limited to 14 AWG for connectors)
AMB Lines: 12–22 AWG
AC Mains: 10–16 AWG
Power (Including Standby)
Input voltage 120 to 240 VAC; 50 to 60 Hz Single-phase (Universal AC/Auto-switching)
Input current 3 Amps
Battery input voltage 40.8 - 55.4 VDC 48 Volts (nominal)
Operating voltage ~48 VDC
Standby time 72 hrs followed by 60 min continuous voice
Continuous signaling time 60 minutes (voice)
Battery charger Universal AC Supply, 4 Amp maximum
Batteries Four (4) deep cycle discharge AGM, SLA batteries. 65 AH each, connected in series
Amplifiers
Amplifier Class D
Frequency response 300 Hz to 7.2 kHz (Driver, typical); 20 Hz to 20 kHz (Amp, typical)
Total harmonic distortion 0.1% THD+N Capable; 10% THD+N Max to achieve specified SPL levels
Efficiency Greater than 90% at full load
Thermal protection Yes
Short circuit protection Yes, Auto Recovery
Driver impedance 11 Ohm (Typical)
Environment
Operating temperature -40° F to 140° F (-40° C to +60° C)
Electronic cabinet rating NEMA 4X, IP66, UL508 cabinet
Transient protection Built-in lightning protection on mains, external interfaces, and speaker lines
a
Not included with the HPSA-7100-R series.
High-Power Speaker Arrays
EATON Voice Evacuation/Mass Notification www.coopernotification.com
73