User`s guide

Advanced Management
72 Eaton Intelligent Power Manager (IPM) User’s Guide v1.40 P-164000289—Rev 2
3. Click the Node List button , select Set Login Parameters, and enter the card Login and Password.
The access status changes from Access Denied (
) to Access OK ( ).
After a few seconds, the Node configuration panel is updated.
4. Click on the Edit button
, or load a previously saved configuration.
5. In the Network Settings Configuration dialog box, chec
k the parameters you want to change and type the
new values (see Figure 78).
Figure 78. Network Section
6. Click Apply to apply to the selected node (card).
NOTE The parameters that have different card and configurations values (unsynchronized)
are indicated by the
sign.
7. Select the parameters you want to synchronize (with the check box).
8. Click Synchronize.
!
IMPORTANT
Some advanced parameter details are not displayed in the Network Settings Configuration dialog
box
. For these details, you will need to change the advanced parameters details directly on one
device and then synchronize the configuration from this device to other devices (see Figure 79).