User`s guide

User Drivers
114 Eaton Intelligent Power Manager (IPM) User’s Guide v1.40 P-164000289—Rev 2
When the rule is created, you can test the rule using the Check result button. See the following section,
“Buttons” for a description of the Check result button.
Figure 129 illustrates the Rule editor dialog.
Figure 129. Rule Editor Dialog
Buttons
The following buttons allow you to create and test rules on the Rule editor dialog.
l
Manage user defined objects...: Allows you to define your own object list to link for a specific device type
l
Browse source object name...: Builds a list to help you to select the appropriate source object from a list of
value
l
Check result: Used to compute the rule result according the given parameters. The source result and the
final rule result are both displayed.
NOTE The Check result button is enabled only if address or the name is entered for Check
with this address/name on the User drivers editor dialog.
l
ok: Accept changes
l
Cancel: Do not accept changes
Destination object name
This field defines the name of the destination object in the Rule editor dialog.