User`s guide

Virtualization
92 Eaton Intelligent Power Manager (IPM) User’s Guide v1.40 P-164000289—Rev 2
Figure 104. Need Title
Configuring Hypervisors
Descriptions of two methods for configuring Hypervisors follow (see “Adding Infrastructure Connectors” on
page 82).
l
If you previously “Added a Manager” in Eaton IPM:
- After you have entered the correct information for the Manager, the Eaton IPM connects to the Manager
(vCe
nter or SCVMM).
- Eaton IPM automatically retrieves the VMHost in
formation and creates new nodes in Eaton IPM for each
VMhost.
- Eaton IPM automatically creates two different types of nodes (you can see the new node in the Node
List).
- The next step is to configure Main
tenance and Shutdown (see “Configuring Maintenance and Shutdown”
on page 93).
l
If you previously “Added a Hypervisor List” in Eaton IPM:
- After you have added a new Hypervisor list, Eaton IPM creates new nodes and waits for credentials.
- The next step is to configure the node creden
tials through the Infrastructure Connector.
- After you have entered the correct information, IPM retrie
ves the Hypervisor information.
- Eaton IPM creates two different types of nodes (you can see the new node in the Node List).
- Eaton IPM automatically creates two different types of nodes (you can see the new node in the Node
List).
- The next step is to configure Main
tenance and Shutdown (see “Configuring Maintenance and Shutdown”
on page 93).