Installation guide

Before you Begin
Tools you Will Need
The following tools are required to successfully install the workstation.
 Common installation tools
 3/8” socket
 TORX driver for M8x36 flathead screws
 #1 and #2 Phillips head screwdriver
 Powered driver
 Spirit (bubble) level
 Hole saw, 2-1/2” diameter
 11/16” nut driver (or socket wrench)
 5/8” nut driver (or socket wrench)
 5/32” Allen wrench
 1-3/8” open end wrench (for leveling glide adjustment)
 Phillips head screwdriver
 Rubber mallet
Fasteners you Will Be Using
Following is an illustration of the fasteners and screws that are provided in the Lift assembly box
(provided in kit labeled PROKIT43-thru-PROKIT46). Front and side views are shown. For a
complete list of parts, refer the section, “Unpack the Box Contents” in Chapter 2.
Item Description
Part
Number
Screws
3 #8-32 x 3/8” flathead, thread
cutting screw
18618
8 Pan head thread form screw
#10-32 x 3/8”
66714
12 M6 x 10mm Phillips pan head
screw
91503
10 1/4-20 x 1/2” pan head screw 83105
15 Phillips pan head screw 97409
5 1/4-20 x 1/2” hex washer thread
form
54348
14 Phillips pan head screw 97408
11 M6 x 20MM Phillips pan head
screw
85234
7 #10A x 1” Phillips pan head
screw
62071
17 M8x36 flathead Torx (supplied
with DL2 by LINAK)
N/A
16 Hex head, 3/8-16 x 2.5” bolt 98129
Front View Side View
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 2