Installation guide

Chapter 4 Aligning the Workstation to the Core
Now that the Profile Genesys Dual-Lift Ergonomic Workstation has been successfully
installed, you will need to align the workstation to the core as documented below.
To install additional system components such as flat panel displays, and so on, refer to the
Profile
®
Flat Panel Console System Installation Manual for detailed instructions.
To align the workstation to the core, do the following:
1. Attach the connector base to the lift base, using thread forming screws (54348) as
shown in the exploded view below.
2. Connect the base to the core by inserting and tightening four (4) thread forming screws
(54348) as shown in the exploded view below.
3. Secure the cover using four (4) #10-32 x 3/8” Pan head swage form screws (66714).
35 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011
Step 
(4x)
90º Corner
Detailed View
Step 
Cover
Connector Base
Step 
(4x)
Lift Base
See detail below