Installation guide

Installing the Ergonomic Workstation
Installation Options for the G111 Series
This section provides instructions on installing the Eaton Profile Genesys G111-Series
Ergonomic Workstation with keyboard tray. Skip this section if you are not installing this
product.
Attach Keyboard Tray
If you ordered the keyword tray, then follow these instructions to attach the keyboard tray to
the user surface.
1. Attach the keyboard assembly below the front of the user surface by hooking the frame to
the user surface support frame.
Step 
(
5x
)
Keyboard
Assembly
Step 
(4x)
User Surface
2.
From below the work surface, insert four Phillips screws (92927) through the keyboard
tray supports into the user surface support frame and tighten.
3. Insert five Phillips screws (92927) horizontally through the keyboard tray bracket into the
front of the user surface support frame and tighten.
4. Initialize the lift by pressing the Down Arrow button on the control pad until the lift column
lowers to the “end-stop” position.
33 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011