Installation guide

Initialize the System
To initialize the lift, do the following:
1. On the control pad, press the Down Arrow button until the lift column lowers to the
“end-stop” position”.
Workstation Model Shown for Illustrative Purposes Only
Installing the Ergonomic Workstation
2. If the controls are not working properly, then refer to the DeskPower DB4/DL4 Systems
Guide to ensure the control pad has been properly installed. Refer to the “Documentation”
section of this manual for document location.
You have now successfully installed and initialized the Profile Genesys Dual-Lift Ergonomic
Workstation and it is ready for operation.
For additional operational information on how to set and store user positions, adjust the height
of the workstation, and switch to a stored memory position, refer to the Profile Genesys Dual-
Lift Ergonomic Workstation Operator’s Manual. The Operator’s Manual also includes
instructions on how to troubleshoot the workstation should any system malfunction occur.
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 32