Installation guide

Installing the Ergonomic Workstation
3. Connect the DL6 cable to Port 1 as shown below.
4. Connect the other DL6 cable to Port 2 as shown below.
5. Connect the DL2 cable to Port 3 as shown below.
6. Connect the power cable to the power outlet as shown below.
7. Connect the controllers to the controller port as shown here.
Port Connections Detail
IMPORT
ANT: Note the connection port assignment. The workstation will not function unless
the lifts are plugged into the correct ports as shown here.
8. Test cable routing and connections. Check all cable routes for pinching and interference.
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 30