Installation guide

Installing the Ergonomic Workstation
Check and Adjust Workstation to Maintain Proper Workstation Spacing
Follow these instructions to check and adjust the workstation setting (if necessary) to ensure
proper spacing between the user surface and the rear surface of the workstation.
To check the spacing between the user and rear surfaces, do the following:
1. Extend the user and rear surfaces to their highest setting.
2. Measure the gap between the surfaces to be 1.5”.
3. If the gap is inconsistent, then check if the workstation is level.
4. If the unit is not level, then loosen the three rear lift (DL2) mid screws (2 side and 1 front)
on the lower support as illustrated below.
Loosen
Screws
(
3x
)
5. Adjust the front and back of the rear surface until the gap is uniform and is 1.5”.
6. Tighten the side screws, and then the front screw.
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 26