Installation guide

Table of Contents
About this Guide
Audience vii
General Conventions vii
Documentation viii
1 Before you Begin
Introduction 1
Important Safety Information 1
Site Preparation 1
Tools you Will Need 2
Fasteners you Will Be Using 2
Washers and Grommets you Will Be Using 3
2 Pre-Installation Preparation and Planning
Prerequisites 5
Installation Overview/Checklist 5
Tools you Will Need 5
Fasteners you Will Be Using 5
Unpack the Box Contents 6
Workstation Components 7
Lifts Covered in this Manual 8
3 Installing the Dual-Lift Workstation
Introduction 9
Install the Rear Lift Column Assembly 10
Attach Lift Column to Base Assembly 10
Install the Front Lift Column Assembly 12
Attach Leg Assembly to Feet 12
Attach Leg Assemblies to Base 13
Attach Leg and Base Support Covers 14
Level Assembled Components 16
Attach Lower Frame 17
Attach Workstation Support 19
Install Rear Surface and Trim Assembly 20
Attach Rear Surface Support Beam 20
Attach Center Column Cable Chains 21
Drill Holes for Flat Panel Display Support 22
Attach Rear Surface Trim Panels 23
Attach Rear Surface 24
Install User Surface and Components 25
Attach User Surface 25
Check and Adjust Workstation to Maintain Proper Spacing 26
Attach Left Cable Chain to User Surface 27
Attach Lift Control Box and Operator Control Pad 28
Route Cables 29
Install the Rear Cover 31
Initialize the System 32
Installation Options for the G111 Series 33
Attach Keyboard Tray 33
4 Aligning the Workstation to the Core
35
v Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation wwww.eaton.com/powerquality 11-41 06-2011