Installation guide

Installing the Ergonomic Workstation
Attach Rear Surface
Follow these instructions and refer to the illustration below to attach the rear surface to the rear
surface support beam.
1. Align the rear surface above the rear surface beam using the flat panel display poles
and/or grommet opening to help with alignment.
2. From the bottom of the rear surface, insert 17 Phillips head screws (62071) through the
support beam into the bottom of the surface and tighten.
Rear Surface
Rear Su
rface
Support Beam
Step 
(17x)
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 24