Installation guide

Installing the Ergonomic Workstation

Attach Workstation Support

Follow these instructions and refer to the illustration below to attach the workstation support to the

assembled components.

CAUTION: To prevent personal injury and product damage, two or more people are required to

perform the following procedure.

1. Align the workstation support over the left and right leg assemblies.

2. Using four lock washers (18950) and four Phillips head screws (91503) per side  two sets in the

front and two sets in the rear  loosely attach the support to the top of each leg.

Step 

(4x)

Ste



Step 

Detail Shown

Level the support, then align to the top of each leg and tighten the eight (8) screws that were

inserted in step 2. See illustration above.

19 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation wwww.eaton.com/powerquality 11-41 06-2011