Installation guide

Installing the Ergonomic Workstation
5. Insert four Phillips head thread form screws (66714) in the screw holes on the lift base cover and
tighten (see the illustration below).
6. Re-install the two lift column screws you removed and retained earlier to the base as shown below.
Step 
Lift Base Cove
r
Step 
(
2x
)
Step 
(4x)
Step 
Step 
You have successfully attached the leg and base covers for the Profile Genesys Ergonomic
Workstation. Proceed to the next section for instructions on leveling the assembled components.
15 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation wwww.eaton.com/powerquality 11-41 06-2011