Installation guide

Installing the Ergonomic Workstation
Install the Front Lift Column Assembly
Follow these procedures to install the front lift column assembly.
Attach Leg Assembly to Feet
Follow these instructions to attach the foot assembly (left and right) to its respective DL6 leg
assembly (left and right). NOTE: The foot bracket and the top of the leg assembly must both be
oriented to its respective foot - left with left and right with right.
NOTE: Make sure the levelers are extended at least 3/4” before you begin the assembly process.
1.
Insert the right leg assembly into the right foot assembly as illustrated below.
2. Insert four M6 x 20MM Phillips pan head screws (85234) with four lock washers (18950) through
the top of the right leg assembly and tighten as illustrated below.
Foot Assembly
Leg Assembly
Step 
(4x)
Leg Assembly
3. Repeat steps 1 and 2 with the left leg assembly and the left foot assembly (see illustration above).
wwww.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 12