Installation guide

Chapter 3 Installing the Dual-Lift Workstation
Introduction
This chapter describes how to install the components of the dual-lift workstation. Installation tasks
include the following:
 Installing the rear lift column assembly
 Installing the front lift column assembly
 Leveling assembled components
 Installing the rear surface and trim assembly
 Installing user surface and components
 Installing optional modules (if applicable)
In this Chapter
Refer to the following table for information on a specific topic.
Topic See Page #
Install the Rear Lift Column Assembly 10
Attach Lift Column to Base Assembly 10
Install the Front Lift Column Assembly 12
Attach Leg Assembly to Feet 12
Attach Leg Assemblies to Base 13
Attach Leg and Base Support Covers 14
Level Assembled Components 16
Attach Lower Frame 17
Attach Workstation Support 19
Install the Rear Surface and Trim Assembly 20
Attach Rear Surface Support Beam 20
Attach Center Column Cable Chains 21
Drill Holes for Flat Panel Display Supports 22
Attach Rear Surface Trim Panels 23
Attach Rear Surface 24
Install the User Surface and Components 25
Attach User Surface 25
Check and Adjust Workstation to Maintain Proper Spacing 26
Attach Left Cable Chain to User Surface 27
Attach Lift Column Control Box and Operator Control Pad 28
Route Cables 29
Install the Rear Cover 31
Initialize the System 32
Install Options for the G111 Series (if applicable) 33
9 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation wwww.eaton.com/powerquality 11-41 06-2011