User Manual

Wiring with easy800
86
08/04 AWB2528-1423GB
Operation
The cursor buttons in the easy800 circuit diagram perform
three functions. The current mode is indicated by the
appearance of the flashing cursor.
•Move
•Entering
• Connect
In Move mode you can use
ÍÚ úí to move the cursor
around the circuit diagram in order to select a rung, contact
or relay coil.
Use OK to switch to Entry mode so that you can enter or
change a value at the current cursor position. If you press
ESC in Entry mode, easy800 will undo the most recent
changes.
Press ALT to switch to Connect mode for wiring contacts and
relays. Press ALT again to return to Move.
Press ESC to leave the circuit diagram and parameter
display.
Opening the parameter display for function blocks
with contacts or relays
If you specify the contact or coil of a function relay type in
Entry mode, easy800 automatically switches from the
contact number to the function block parameter display
when you press OK.
Press
í to switch to the next contact or coil field without
entering any parameters.
â
I 01
l
h
easy800 performs many of these cursor movements
automatically. For example, easy800 switches the cursor
to Move mode if no further entries or connections are
possible at the selected cursor position.