User Manual

Configuring an easy-NET
network
81
08/04 AWB2528-1423GB
Configuring an easy-NET network
The easy-NET network can only be configured by station 1.
Requirement:
All stations are correctly connected to the network and the
termination resistors have been connected.
All stations have a power supply and are in STOP mode. The
POW LED is permanently lit. The NET LED is permanently lit.
X Proceed to the CONFIGURE menu item and press the OK
button.
You will be asked to acknowledge whether you want to
configure the system.
X Press the OK button.
The message on the left appears:
All NET LEDs on the stations which are assigned station
numbers higher than 1 (2 to 8) switch to the OFF state of
easy-NET.
As soon as the configuration has been successfully
completed, the NET LEDs on all stations flash. The easy-NET
network is ready for operation.
If you want to overwrite the station address press the OK
button. The configuration can be aborted by pressing the
ESC button.
h
If the connected stations are being configured, all stations
automatically switch to the STOP mode.
NET PARAMETERS..
STATIONS...
CONFIGURE
CONFIGURE ?
CONFIGURATION
IN
PROGRESS.
h
An error message will appear if a station is assigned with
a station address which does not correspond to the
physical location in the station list.
ERR:ID-KONFLIKT
CONFIGURATION
OVERWRITE?