User Manual

Commissioning
74
08/04 AWB2528-1423GB
Testing the circuit diagram
X Switch to the main menu and select the STOP RUN menu
option.
With a tick at RUN or STOP you switch to the RUN or STOP
operating modes.
easy runs in the mode indicated by the tick.
X Press the OK button. easy will change to RUN mode.
The Status display shows the current mode and the
switching states of the inputs and outputs.
X Change to the Status display and press push-button
actuator S1.
The contacts (boxes) for inputs I1 and I2 are activated and
relay Q1 picks up. This is indicated on the numbers which are
displayed.
Power flow display
easy allows you to check rungs in RUN mode. This means
that you can check your circuit diagram via the built-in
power flow display while it is being processed by the easy.
X Change to the Circuit diagram display and press push-
button actuator S1.
The relay picks up. easy shows the power flow.
Figure 45: Power flow display: Inputs I1 and I2 are closed, relay
Q1 has picked up
= visible area
PROGRAM...
STOP å RUN
PARAMETERS
SET CLOCK
h
The mode assigned with the tick is always active.
I 12..........
IP-
MO 14:42
Q 1....... RUN
I 01====I 02===================Ä Q 01
L: 1 C:1 RUN