User Manual

08/04 AWB2528-1423GB

2 Installation

The easy must only be installed and wired up by qualified

electricians or other persons familiar with the installation of

electrical equipment.

The easy is installed in the following order:

• Mounting,

• Wiring up the inputs,

• Wiring up the outputs,

• Wiring up the NET network (if required),

• Connecting the power supply.

Mounting Install easy in an enclosure, switch cabinet or distribution

board so that the power feed and terminal connections

cannot be touched accidentally during operation.

Snap easy onto a IEC/EN 60715 top-hat rail or fix easy in

place using fixing brackets. easy can be mounted vertically

or horizontally.

Danger of electric shock!

Never carry out electrical work on the device while the

power supply is switched on.

Always follow the safety rules:

• Switch off and isolate,

• Ensure that the device is no longer live,

• Secure against reclosing,

• Short-circuit and ground,

• Cover adjacent live parts.

When using the easy with expansion units, connect the

expansion concerned before mounting (see a page 34).