User Manual

easy Settings
278
08/04 AWB2528-1423GB
Deactivating the P buttons
X Select P BUTTONS å and press OK.
easy changes the display to
P BUTTONS and the P buttons
are deactivated.
Startup behaviour The startup behaviour is an important aid during the
commissioning phase. The circuit diagram which easy
contains is not as yet fully wired up or the system or machine
is in a state which easy is not permitted to control. The
outputs should not be controlled when easy is switched on.
Setting the startup behaviour
Requirement: easy must contain a valid circuit diagram.
X Switch to the System menu.
Specify the operating mode which easy must use when the
supply voltage is applied.
Activating RUN mode
If easy displays
RUN MODE å, this means that easy will
start in Run mode when the supply voltage is applied.
h
The P buttons are automatically deactivated when loading
a circuit diagram from the memory card or via
EASY-SOFT (-PRO) to easy, or when deleting a circuit
diagram in easy.
h
The easy devices without a display can only be started in
RUN mode.
h
If easy is protected by a password, the System menu will
not be available until easy is “unlocked” (see a Section
“Unlocking easy” from Page 267).