User Manual

easy Settings
272
08/04 AWB2528-1423GB
X Select the required function block with Í or Ú .
X Press the OK button.
X Scroll with the Í or Ú cursor buttons through the
constants of the function block inputs.
X Change the values for a parameter set:
–With OK in the Entry mode.
–
úí change decimal place
–
ÍÚ change the value of a decimal place
– OK save constants or
– ESC Retain previous setting.
Press ESC to leave the parameter display.
Adjustable parameters for function blocks
You can modify the function blocks used in the circuit
diagram in three different ways:
• All circuit diagram parameters can be adjusted in STOP
mode via the function block editor.
• Setpoints (constants) can be modified in RUN mode via
the function block editor.
• Setpoints (constants) can be modified via the
PARAMETERS menu.
Adjustable setpoint values are:
• The inputs with all function blocks if constants have been
used.
• Switch on and off times with time switches.
In RUN mode easy operates with a new setpoint as soon as
it has been modified in the parameter display and saved with
OK.
T 03 Ü S +
>I1 020.030
>I3 005.000
QV> 012.050
h
Only constants on the function block inputs can be
changed.