User Manual

Changing parameters
271
08/04 AWB2528-1423GB
easy will now show the new menu language.
Press ESC to return to the Status display.
Changing parameters easy allows you to change function relay parameters such as
timing relay setpoint values and counter setpoints without
having to call up the circuit diagram. This is possible
regardless of whether easy is running a program or is in
STOP mode.
X Press OK to switch to the main menu.
X Start the parameter display by selecting PARAMETERS.
All function blocks are displayed as a list.
The following preconditions must be fulfilled in order for a
parameter set to be displayed:
• A function relay must have been included in the circuit
diagram.
• The PARAMETERS menu must be available.
• The parameter set must have been enabled for access,
indicated by the + character at the bottom right of the
display.
SICUREZZA...
SISTEMA...
LINGUA MENU...
CONFIGURATORE...
T 03 Ü S +
CP08 -
C 17 +
L: 1 RUN
h
Parameter sets can only be enabled or protected via the
FUNCTION RELAYS menu, or via the circuit diagram with
the “+” enable and with “–” inhibit parameter set
characters.