User Manual

easy operation
23
08/04 AWB2528-1423GB
easy800 LED display
easy800 has two LEDs located on the front which indicate
the state of the power supply voltage (POW) as well as the
RUN or STOP modes (a Fig. 1, Page 18).
Table 1: LED power supply/RUN-STOP mode
Table 2: easy-NET LED (easy-NET)
LED OFF
No power supply
LED continuously lit Power supply present, STOP mode
LED flashing Power supply present, RUN mode
LED OFF
easy-NET not operational, fault, in
configuration
LED continuously lit
easy-NET is initialised and no station has
been detected.
LED flashing easy-NET operating fault-free