User Manual

Wiring with easy800
246
08/04 AWB2528-1423GB
X Confirm the value input with OK.
X Press ESC to leave circuit diagram entry.
X Complete the circuit diagram.
X Test the circuit diagram using the power flow display.
X Switch easy800 to RUN mode and return to the circuit
diagram.
Each parameter set can be displayed using the power flow
display for the circuit diagram.
X Move the cursor onto C 01 and press OK.
The parameter set for the counter is displayed with actual
and setpoint values.
X Move the cursor Ú downwards until you see the value
QV>.
X Switch the input I5. The actual value changes.
On the display
C_ indicates that the counting coil is
actuated.
If the actual and upper setpoint values of the counter are the
same, the timing relay switches the warning light on and off
every 2 seconds.
Doubling the flashing frequency:
X Select the power flow display T 01 and change the
constant of the setpoint time to
001.000.
When you press OK, the warning light will flash at twice the
frequency.
On the display
EN indicates that the enable coil is actuated.
Setpoint value settings with constants can be modified via
the PARAMETERS menu.
C 01 +
>SL
>SV
QV>+0
C 01 +
>SL
>SV
QV>+1
.. C_ .. ..
T 01 Ü S +
>I1 001.000
>I2
QV> 0.550
.. EN..
h
The actual value is only displayed in RUN mode. Call up
the parameter display for this via the power flow display
or PARAMETERS menu.