User Manual

Function blocks
245
08/04 AWB2528-1423GB
The first part of the parameter set of a counter is displayed.
X Proceed with the cursor í over the + character to the value
input behind
>SH:
–
>SH means: function block input upper counter
setpoint value
–The
+ character means that the parameters of this
timing relay can be modified using the PARAMETERS
menu.
X Change the upper counter setpoint to 10:
–Use
úí to move the cursor onto the tens digit.
–Use
ÍÚ to modify the value of the digit.
X Press OK to save the value and ESC to return to the circuit
diagram.
X Enter the circuit diagram up to contact T 01 of the timing
relay. Set the parameters for
T 01.
The timing relay works like a flashing relay. The easy800
symbol for the flashing relay is
Ü. The function is set on the
top right beside the number in the parameter display.
The time base is set to the right of the “flashing” function.
Leave the time base set to
S for seconds.
X Proceed with the cursor to the right over the + character in
order to input the time setpoint value
>I1.
If the same setpoint value is input for
>I1 and >I2, the
timing relay functions as a synchronous flasher.
The
+ character means that the parameters of this timing
relay can be modified using the PARAMETERS menu.
h
If the cursor is on the contact number, easy800 will call up
the parameter display when you press OK.
C 01 +
>SH +10
>SL
>SV
h
easy800 has specific parameter displays for the function
blocks. The meaning of these parameters is explained
under each function block type.
T 01 Ü S +
>I1 002.000
>I2 002.000
QV>