User Manual

15
08/04 AWB2528-1423GB
1easy800
Target readership easy must only be installed and wired up by trained
electricians or other persons familiar with the installation of
electrical equipment.
A specialist knowledge of electrical engineering is needed
for commissioning and creating circuit diagrams. When
controlling active components such as motors or pressure
cylinders, parts of the system can be damaged and persons
put at risk if easy is connected or programmed incorrectly.
Proper use easy is a programmable switching and control device and is
used as a replacement for relay and contactor control
circuits. easy must be properly installed before use.
easy is designed to be installed in an enclosure, switch
cabinet or distribution board. Both the power feed and the
signal terminals must be laid and covered so as to prevent
accidental contact.
The installation must conform to regulations for
electromagnetic compatibility (EMC).
The power up of the easy must not cause any hazards arising
from activated devices, such as unexpected motor startups
or power ups.
Improper use
easy should not be used as a substitute for safety-related
controls such as burner or crane controls, emergency-stop or
two-hand safety controls.