User Manual

Function blocks
179
08/04 AWB2528-1423GB
D 02 to D 32:
If several texts are present and are triggered, each text is
automatically displayed in succession every 4 s. This
procedure is repeated until
• none of the text output function blocks are set to 1.
• STOP mode is selected.
• the easy power supply is switched off.
•the OK or DEL + ALT buttons are used to switch to a
menu.
• the text for D01 is displayed.
The following applies to D 01
: D1 is assigned as an alarm text. If D01 is activated, the text
assigned to it will be displayed until
• the coil D 01EN is reset to 0.
• STOP mode is selected.
• the easy power supply is switched off.
•the OK or DEL + ALT buttons are used to switch to a
menu.
Text entry
Text entry is only possible using EASY–SOFT, from version
V 4.0 upwards.
Character set
All ASCII characters in upper and lower case are permissible.
• A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
• a b c d e f g h i j k l m n o p q r s t u v w x y z
The following special characters are permissible:
! „“ # $ % & ` () * + , – ./0 1 2 3 4 5 6 7 8 9