Datasheet

500 W at 115/120 V AC Operations  25000
Fluorescent lamp load   
Fluorescent lamp load 10 x 58 W at 230/240 V AC   
With upstream electrical device Operations  25000
Uncompensated Operations  25000
Fluorescent lamp load 1 x 58 W at 230/240 V AC, conventional, compensated Operations  25000
Switching frequency   
Mechanical operations 
x 10
6
10
Switching frequency  Hz 10
Resistive load/lamp load  Hz 2
Inductive load  Hz 0.5
UL/CSA   
Uninterrupted current at 240 V AC  A 10
Uninterrupted current at 24 V DC  A 8
AC   
Control Circuit Rating Codes (utilization category)   B 300 Light Pilot Duty
Max. rated operational voltage  V AC 300
max. thermal continuous current cos ϕ = 1 at B 300  A 5
max. make/break cos ϕ ≠ capacity 1 at B 300  VA 3600/360
DC   
Control Circuit Rating Codes (utilization category)   R 300 Light Pilot Duty
Max. rated operational voltage  V DC 300
Max. thermal uninterrupted current at R 300  A 1
Max. make/break capacity at R 300  VA 28/28
Ethernet
Data transfer rate  Mbit/s 10/100
Connections   RJ45 plug, 8-pin
Cable   CAT5
Design verification as per IEC/EN 61439
Technical data for design verification   
Static heat dissipation, non-current-dependent P
vs
W 3
Operating ambient temperature min.  °C -25
Operating ambient temperature max.  °C 55
IEC/EN 61439 design verification   
10.2 Strength of materials and parts   
10.2.2 Corrosion resistance   Meets the product standard's requirements.
10.2.3.1 Verification of thermal stability of enclosures   Meets the product standard's requirements.
10.2.3.2 Verification of resistance of insulating materials to normal heat   Meets the product standard's requirements.
10.2.3.3 Verification of resistance of insulating materials to abnormal heat
and fire due to internal electric effects
  Meets the product standard's requirements.
10.2.4 Resistance to ultra-violet (UV) radiation   Meets the product standard's requirements.
10.2.5 Lifting   Does not apply, since the entire switchgear needs to be evaluated.
10.2.6 Mechanical impact   Does not apply, since the entire switchgear needs to be evaluated.
10.2.7 Inscriptions   Meets the product standard's requirements.
10.3 Degree of protection of ASSEMBLIES   Meets the product standard's requirements.
10.4 Clearances and creepage distances   Meets the product standard's requirements.
10.5 Protection against electric shock   Does not apply, since the entire switchgear needs to be evaluated.
10.6 Incorporation of switching devices and components   Does not apply, since the entire switchgear needs to be evaluated.
10.7 Internal electrical circuits and connections   Is the panel builder's responsibility.
10.8 Connections for external conductors   Is the panel builder's responsibility.
10.9 Insulation properties   
10.9.2 Power-frequency electric strength   Is the panel builder's responsibility.
10.9.3 Impulse withstand voltage   Is the panel builder's responsibility.
10.9.4 Testing of enclosures made of insulating material   Is the panel builder's responsibility.
06/13/2019 Eaton Y7-197212 ED2019 V57.0 EN 5 / 8