User Manual

The xStart contactor series has been extended by
two further current ranges
The series for contactors has been extended in 55 mm
widths to 72 A and in 90 mm widths to 170 A.
With the smaller dimensions the DILM72 or the
DILM170 are an attractively-priced alternative for
simple switching conditions up to 37 kW and 90 kW
respectively.
The known features of the xStart product series apply
to the features of the new contactors: Proven quality,
easy to install and low holding power on DC operated
contactors are just some examples.
New motor filter for tool-less plug connection
technology
High inductive voltage peaks during switch off exceed
the operating voltage by several times and as a result
overload the loads.
The motor filter is simply plugged into the contactors
up to 15.5 A without any complex mounting
operations.
The R/C suppressor circuit attenuates the voltage
peaks to a low level so that the motor is protected.
Simple design of your own solution with tool-less
plug connections
The advantages of the Moeller printed board contacts
result from the simple mechanical connection
between circuit boards and contactors. The board
is mechanically retained on the fixing plate via clips.
The printed board contact is bound in a 45 mm grid
dimension. The shape of the fixing plate has the
same contour as the contactor. Contactors can also
be exchanged later – after a fault – without the need
for soldering.
The printed board contact allows users to implement
their own applications directly on the contactor.