Installation Manual

Chapter 6—Installation Requirements
26 DG1 Series VFD MN040002EN—March 2014 www.eaton.com
Standard Drive Mounting
FR1 Mounting Instructions
Step 1: Lift the drive out from the carton. Remove the
packaging.
Step 2: Attach the drive to the mounting plate with four
M5x15 or 3/16 inch screws and four M5 or 3/16 inch
nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer to
the drive mounting template printed on the outside
carton).
FR2 Mounting Instructions
Step 1: Lift the drive out from the carton. Remove the
packaging.
Step 2: Attach the drive to the mounting plate with four
M5x15 or 3/16 inch screws and four M5 or 3/16 inch
nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer to
the drive mounting template printed on the outside
carton).
Screw: Four M5x15
or 3/16 inch
Nut: Four M5
or 3/16 inch
Screw: Four M5x15
or 3/16 inch
Nut: Four M5
or 3/16 inch