Firmware Manual

Chapter 3—Menu Overview
22 PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com
4. P21.1.7 Password
Password protects the parameters’ security. Zero means
not used, otherwise in use. If password is in use, user
can still see the values of parameters, but needs to
check the password before editing. And user has to
check the old password before modifying it.
0000 shall mean that the password is not used, the
password is 0000 by default.
The password range shall be 0001–9999, the setting of
password and checking of password are as Figure 4-21.
Enter the password setting page. If the password is
0000, then the “Not use” shall be shown. If the
password is not 0000, then the “in use” shall be shown.
If the password is in use, and user inputs the wrong
password, then the “failed” shall be shown.
After “failed” is shown 3 seconds, the page shall return
to the parameter read page.
If the password is in use, and user inputs the right
password, then the value shall flash, which indicates that
it can be edited.
Figure 24. Password
Note: Please contact Eaton customer support if password
is forgotten.