Firmware Manual

Appendix A—Description of Parameters
PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com 185
P20.3.7 1503 Static Subnet Mask 1, 2, 3, 4 RW
The static IP address. This parameter is used for user to configure the subnet mask,
when P20.3.1 is set to be 1.
P20.3.8 1505 Static Default Gateway 1, 2, 3, 4 RW
The static IP address. This parameter is used for user to configure the default
gateway, when P20.3.1 is set to be 1.
P20.3.9 608 EtherNet/IP Protocol Status 1, 2, 3, 4 RO
Indicates if Ethernet Protocol is active or not.
0 Stopped
1 Operational
2 Faulted
P20.3.10 609 Connection Limit 1, 2, 3, 4 RW
Maximum number of connections allowed to the frequency converter.
P20.3.11 610 Modbus TCP Unit ID 1, 2, 3, 4 RW
Unit identifier unit value for Modbus TCP.
P20.3.12 611 Comm Timeout 1, 2, 3, 4 RW
Selects the time it waits before a communication fault occurs over Ethernet.
P20.3.13 612 Protocol Status 1, 2, 3, 4 RO
0 Stopped
1 Operational
2 Faulted
P20.3.14 613 Slave Busy 1, 2, 3, 4 RO
Value indicates frequency converter is communicating.
P20.3.15 614 Parity Error 1, 2, 3, 4 RO
This parameter checks the input characters’ parity error.
P20.3.16 615 Slave Failure 1, 2, 3, 4 RO
Indicates the frequency converter is unable to process message.
P20.3.17 616 Last Fault Resp 1, 2, 3, 4 RO
Shows the last active fault that occurred.
P21.1.1 340 Language 1, 2, 3, 4 RW
This parameter offers the ability to control the frequency converter through the
keypad in the language of your choice. Currently available languages are: English,
Chinese, German, Spanish, French and Portuguese.
P21.1.2 142 Application 1, 2, 3, 4 RW
This parameter sets the active application if multiple applications have been loaded.
P21.1.3 619 Parameter Sets 1, 2, 3, 4 RW
This parameter allows you to reload the factory default parameter values, and to
store and load two customized parameter sets.
0 No
1 Load Factory Default parameters
2 Store parameter set #1
3 Load parameter set #1
4 Store parameter set #2
5 Load parameter set #2
P21.1.4 620 Up to Keypad 1, 2, 3, 4 RW
This function uploads all existing parameter groups to the keypad.
0 No
1 Yes (All parameters)
Code Modbus ID Parameter Application
RO/RW