Firmware Manual

Chapter 8—Multi-Purpose Application
114 PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com
Notes
1
Parameter value can only be changed after the drive has stopped.
2
Parameter value will be set to be default when changing macros.
P6.3
2
Logic Operation Input B 0 753 0 = Not Used
1 = Ready
2 = Run
3 = Fault
6 = Reversed
7 = Warning
8 = Zero Frequency
9 = Control from I/O
15 = Ext Brake Control
16 = Bypass Run
17 = At Speed
18 = Remote Control
19 = Freq Limit 1 Superv
20 = Freq Limit 2 Superv
22 = PID1 Superv
23 = PID2 Superv
24 = Overheat Warning
28 = 4 mA Ref Fault/Warning
29 = Overcurrent Regular
30 = Overvoltage Regular
31 = Undervoltage Regular
32 = Torq Limit Superv
33 = Ref Limit Superv
34 = Un-Requested Rotation
Direction
35 = Thermal Fault/Warning
36 = Bypass Run
37 = Jog Speed Select
38 = Motor Therm Protection
39 = FB Digital Input 1
40 = FB Digital Input 2
41 = FB Digital Input 3
42 = FB Digital Input 4
43 = Damper Control
44 = TC1 Status
45 = TC2 Status
46 = TC3 Status
47 = In E-Stop
48 = Power Limit Superv
49 = Temp Limit Superv
50 = Analog Input Superv
51 = Motor 1 Control
52 = Motor 2 Control
53 = Motor 3 Control
54 = Motor 4 Control
55 = Motor 5 Control
56 = Logic Fulfilled
Table 99. Drive Control—P7
Code Parameter Min. Max. Unit Default ID Note
P7.1
2
Remote 2 Control Place 1 138 See P1.11
P7.2
12
Remote 2 Reference 7 139 See P1.12
P7.3
2
Keypad Reference Par. P1.1 Par. P1.2 Hz 0.00 141
P7.4
2
Keypad Direction 0 116 0 = Forward
1 = Reverse
P7.5
2
Keypad Stop 1 114 0 = Enabled-Keypad Operation
1 = Always Enabled
P7.6
2
Jog Reference Par. P1.1 Par. P1.2 Hz 0.00 117
Table 98. Logic Function—P6, continued
Code Parameter Min. Max. Unit Default ID Note