Quick Start Guide

Step 5—Standard Parameter List
PowerXL DG1 Series Adjustable Frequency Drives MN040012EN—March 2014 www.eaton.com 23
Notes
1
Parameter value can only be changed after the drive has stopped.
2
Parameter value will be set to be default when changing macros.
Table 21. EtherNet/IP / Modbus TCP—P20.3
Code Parameter Min. Max. Unit Default ID Note
P20.3.1 IP Address Mode 1 1500 0 = Static IP
1 = DHCP with AutoIP
P20.3.2 Active IP Address 1507
P20.3.3 Active Subnet Mask 1509
P20.3.4 Active Default Gateway 1511
P20.3.5 MAC Address 1513
P20.3.6 Static IP Address 192.168.1.254 1501
P20.3.7 Static Subnet Mask 255.255.255.0 1503
P20.3.8 Static Default Gateway 192.168.1.1 1505
P20.3.9 EtherNet/IP Protocol Status 0 608 0 = Stopped
1 = Operational
2 = Faulted
P20.3.10 Connection Limit 0 2 2 609
P20.3.11 Modbus TCP Unit ID 1 610
P20.3.12 Comm Timeout Modbus TCP ms 2000 611
P20.3.13 Protocol Status 0 612 0 = Stopped
1 = Operational
2 = Faulted
P20.3.14 Slave Busy 0 613 0 = Not Busy
1 = Busy
P20.3.15 Parity Error 0 614
P20.3.16 Slave Failure 0 615
P20.3.17 Last Fault Response 0 616
Table 22. Basic Setting—P21.1
Code Parameter Min. Max. Unit Default ID Note
P21.1.1 Language 0 340 0 = English
1 = English
2 = English
P21.1.2
1
Application 0 142 0 = Standard
1 = Multi-Pump
2 = Multi-PID
3 = Multi-Purpose
P21.1.3 Parameter Sets 0 619 0 = No
1 = Reload Defaults
2 = Reload Set 1
3 = Reload Set 2
4 = Store Set 1
5 = Store Set 2
6 = Reset
P21.1.4 Up To Keypad 0 620 See P21.3.1
P21.1.5 Down From Keypad 0 621 0 = No
1 = All Parameters
2 = All, No Motor
3 = App Parameters