Firmware Manual

Chapter 3—Menu Overview
18 PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com
P—Parameter
The navigation for parameter is as Figure 20.
In parameter page, the parameter code shall be shown in the
second line (such as P1.1), align the text to the left.
In parameter page, the parameter name shall be shown in
the third line (such as Min Frequency), align the text to the
left.
In parameter page, the value of parameter and unit shall be
shown in the fourth line (0.00 Hz), align the text to the left.
If the parameter is read and write, then pressing the right key
shall make the parameter value flash, which means that the
value can be edited.
If the parameter is read only, then pressing the right key will
not have any effect, which means that the value can’t be
edited.
Figure 20. Parameter Menu Overview
There are several special pages:
1. P21.1.3 Parameter Sets. See Figure 21.
User shall be able to load or store parameters. There are
default, set1 and set2 parameters that can be used. The
special points are:
●
During this operation, “waiting…” shall flash, which
means it is in process.
●
When it is finished, “OK” shall be shown.
●
Drive shall restart after default parameters are loaded.