Firmware Manual

Appendix A—Description of Parameters
188 PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com
P21.4.3 601 Total MWh Count 1, 2, 3, 4 RO
Megawatt hours total operation time counter.
P21.4.4 603 Total Power Day Count 1, 2, 3, 4 RO
Number of days the GMAX has been supplied with power.
P21.4.5 606 Total Power Hr Count 1, 2, 3, 4 RO
Number of hours the GMAX has been supplied with power.
P21.4.6 604 Trip MWh Count 1, 2, 3, 4 RW
Megawatts hours since last reset.
P21.4.7 635 Clear Trip MWh Count 1, 2, 3, 4 RW
Resets megawatts hours counter and clears Energy Meter in the Menu (P21.4.7).
P21.4.8 636 Trip Power Day Count 1, 2, 3, 4 RW
Number of days since the last reset.
P21.4.9 637 Trip Power Hr Count 1, 2, 3, 4 RW
Number of hours the HVX9000 has been running a motor since the last reset.
P21.4.10 639 Clear Trip Power Count 1, 2, 3, 4 RW
Resets the day and hour motor or drive running counter and resets the Motor Run
Time in the Menu (P21.4.9 and P21.4.10).
M1 1 Output Frequency 1, 2, 3, 4 RO
Drive output frequency going to the motor. This value should match reference
frequency when in frequency control mode.
M2 24 Frequency Reference 1, 2, 3, 4 RO
Drive frequency reference value. Motor output frequency should match this value in
frequency control mode.
M3 2 Motor Speed 1, 2, 3, 4 RO
Motor speed is calculated based on the V/Hz curve that was set up when motor
parameters were entered.
M4 3 Motor Current 1, 2, 3, 4 RO
Measured output motor current.
M5 4 Motor Torque 1, 2, 3, 4 RO
Percent calculated motor torque based on the current draw of the motor and its
nameplate values.
M6 5 Motor Power 1, 2, 3, 4 RO
Percent calculated motor power based on the current and voltage draw of the motor
and its nameplate values.
M7 6 Motor Voltage 1, 2, 3, 4 RO
Measured output AC motor voltage.
M8 7 DC Link Voltage 1, 2, 3, 4 RO
Measured DC bus voltage.
M9 8 Unit Temperature 1, 2, 3, 4 RO
Measured drive heat sink temperature in °C.
M10 9 Motor Temperature 1, 2, 3, 4 RO
Calculated motor temperature value in percentage. Value is based on motor
nameplate data and the motor status information noted on power up.
M11 15 Torque Reference 4 RO
Torque reference percentage used when in torque control mode.
M12 10 Analog Input 1 1, 2, 3, 4 RO
Analog input 1 measured value. Can be a current or voltage input signal.
M13 11 Analog Input 2 1, 2, 3, 4 RO
Analog input 2 measured value. Can be a current or voltage input signal.
Code Modbus ID Parameter Application
RO/RW