Firmware Manual

Appendix A—Description of Parameters
PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com 171
P10.27 1326 PID1 Set Point 2 Sleep Delay 2, 3, 4 RW
The minimum amount of time the frequency has to remain below the sleep level
before the drive is stopped.
P10.28 1327 PID1 Set Point 2 Wake-Up Level 2, 3, 4 RW
Defines the level for the PID feedback value wake-up supervision. Uses selected
process units.
P10.29 1329 PID1 Set Point 2 Boost 2, 3, 4 RW
The setpoint can be boosted with a digital input.
P10.30 1330 PID1 Feedback Function 2, 3, 4 RW
Choose a single signal used as feedback.
P10.31 1331 PID1 Feedback Gain 2, 3, 4 RW
Define Gain associated with feedback.
P10.32 1332 PID1 Feedback 1 Source 2, 3, 4 RW
Define where feedback signal is from.
P10.33 1333 PID1 Feedback 1 Min 2, 3, 4 RW
Minimum Unit Value.
P10.34 1334 PID1 Feedback 1 Max 2, 3, 4 RW
Maximum Unit Value.
P10.35 1335 PID1 Feedback 2 Source 2, 3, 4 RW
Define where feedback signal is from.
P10.36 1336 PID1 Feedback 2 Min 2, 3, 4 RW
Define feedback2 Minimum Value.
P10.37 1337 PID1 Feedback 2 Max 2, 3, 4 RW
Define feedback2 Maximum Value.
P10.38 1338 PID1 Feedforward Func 2, 3, 4 RW
Choose a single signal used as feed forward.
P10.39 1339 PID1 Feedforward Gain 2, 3, 4 RW
Define feed forward gain.
P10.40 1340 PID1 Feedforward 1 Source 2, 3, 4 RW
Define where feed forward signal is from.
P10.41 1341 PID1 Feedforward 1 Min 2, 3, 4 RW
Define feed forward Minimum Value.
P10.42 1342 PID1 Feedforward 1 Max 2, 3, 4 RW
Define feed forward Maximum Unit Value.
P10.43 1343 PID1 Feedforward 2 Source 2, 3, 4 RW
Define where feed forward signal is from.
P10.44 1344 PID1 Feedforward 2 Min 2, 3, 4 RW
Define feed forward2 Minimum Unit Value.
P10.45 1345 PID1 Feedforward 2 Max 2, 3, 4 RW
Define feed forward2 Maximum Unit Value.
P10.46 1352 PID1 Set Point 1 Comp Enable 2, 3, 4 RW
Enables pressure loss compensation for setpoint 1.
P10.47 1353 PID1 Set Point 1 Comp Max 2, 3, 4 RW
Value added proportionally to the frequency.
P10.48 1354 PID1 Set Point 2 Comp Enable 2, 3, 4 RW
Enables pressure loss compensation for setpoint 2.
Code Modbus ID Parameter Application
RO/RW