Technical data

April 2008
16-14
For more information visit: www.eaton.com PG03300001E
Accessories & Modification Codes
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
Accessories
Advantage NEMA
DeviceNet™ Communications
Module
DeviceNet Module
The DeviceNet Communications mod-
ule (Catalog Number WPONIDNA) is
designed to plug into the Advantage
with the attached cable and plug. The
module can be snapped onto the top
or bottom of the Advantage unit. It can
also be mounted separately using the
mounting plate assembly (Catalog
Number WPONIBASE). The module
provides DeviceNet users with the
ability to control and monitor the func-
tions of the Advantage system at 125,
250 or 500 kbaud. A connector is pro-
vided so that a HAND/OFF/AUTO hard
contact may be used to selectively
enable or disable the output of the
control functions from the module
without affecting its ability to monitor.
A “Feedback” input is provided so that
the state of an auxiliary contact may
be read over the DeviceNet network.
Three bicolor LEDs indicate:
■ DeviceNet address
■ Network status (including
connected, not connected, not
powered)
■ Module status (including normal
operation, minor fault, needs
commissioning)
Table 16-46. DeviceNet Interface
Note: See Cutler-Hammer Control Catalog
for WPONI Network Interface.
Description Catalog
Number
DeviceNet Interface
Module
WPONIDNA
Mounting Plate
Assembly
WPONIBASE
Type W Auxiliary Contact Modules
■ Provides four separate contact sets
which wire vertically and are color
coded; black designates NC and
silver designated NO.
■ Up to two auxiliary contact modules
can be mounted for a total of up to
eight contact sets.
■ Provides circuit isolation (no polar-
ity restrictions) and single break
bifurcated contacts.
■ Common design fits all Sizes 1 – 6.
Table 16-47. Ratings
Table 16-48. Auxiliary Contact Modules
Bell Alarm Module
Bell Alarm Module
■ Simple snap-on mounting
■ Isolated NO and NC contacts
(1 each)
■ Plugs into Reset port
■ Remote electrical Reset wired to
Catalog Number WBELL module
Table 16-49. Ratings
Transformer Pilot Light Kits
Table 16-50. Transformer Pilot Light Kits
Voltage Make Break
NEMA A600 —
120 – 600V AC
7200 VA 720 VA
NEMA Q300 —
125 – 300V DC
69 VA 69 VA
Description Catalog
Number
2NO, 2NC
3NO, 1NC
4NO
4NC
1NO, 3NC
1NO, 1NC and
2 Tie Points
W22
W31
W40
W04
W13
W11T
Form C Contact Ratings
Maximum Amperes —
120V AC
Catalog
Number
Make Break
2880 VA 480 VA WBELL
Continuous Current Rating: 5A
Voltage Color Legend
Plate
Catalog
Number
Replacement
Part
120
240
480
600
Red
Red
Red
Green
RUN
RUN
RUN
OFF
PLK1R
PLK2R
PLK4R
PLK1G
99-3590-1
99-3590-3
99-3590-6
99-3590-8