User`s guide

Eaton

ConnectUPSt Web/SNMP Card User's Guide S 164201405 Rev E www.eaton.com/powerquality

Chapter 2 Remote Configuration

Use the following procedures to access the ConnectUPS Web/SNMP

Card's configuration menus through a Web browser or Telnet utility.

NOTE Not all settings are configurable through both interfaces. For example, the following

security-related and hardware parameters cannot be configured through a Web browser:

Network Connection Test (Ping utility), Enable/disable TFTP, Telnet, HTTP control and security

settings, and HTTP port number setting.

If you prefer to configure the card locally instead, refer to the Quick Start

Instructions.

Set Up the IP Address

To set up the IP address:

1. Verify that an active 10/100BaseT cable is connected to the card's

network connector (the Uplink Port 1 Ethernet connector on the

ConnectUPS-X).

2. If the IP address of the computer is on the same network with the

card, you can run the Web browser directly; continue to the

following section, “Configure the Card.” Otherwise, continue to the

following step.

NOTE The default IP address of the card is 192.168.7.18.

3. If the IP address of the computer is not on the same network with

the card, set up the computer's TCP/IP protocol parameters

temporarily to the 192.168.7.x subnet.

NOTE Refer to the operating system documentation for additional details on changing the

computer's IP address.

NOTE The computer and the card must be on the same subnet for configuration. You can

change the card's IP address to match your local subnet during configuration.