Specifications

ManualsBrandsEaton ManualsPrint & Scan825 UPS

181

182

183

184

185

186

187

188

189

190

BATTERY OPERATING TEMPERATURES

Annual average Any cell temperature not to exceed

battery temperature for more than 30 days per year

F(25

F(32

Normal battery float/cycle life may be expected only when the battery is operated under the aforementioned temperature conditions. If

operation of the battery is not within these parameters, the battery warranty shall be null and void.

Useful service life is considered to have expired when the battery fails to deliver 80% of its rated string capacity. The rated string capacity is that

which is published in EnerSys catalog literature at the time of shipment. The determination of actual capacity shall be made in accordance with the

“performance test” guidelines of IEEE Std. 1188. If the battery is maintained per the installation/maintenance instructions and other

recommendations contained in this document and fails to deliver 80% of its rated string capacity, EnerSys shall credit the purchaser (user) toward the

purchase of a new EnerSys battery of equal or greater amp-hour capacity.

Either the cycle or float service warranty will be used to determine warranty credit. The type of duty that shows the most use will be the

governing factor.

Cycle Credit – Cycle credit is determined on battery usage. An approved cycle monitor must be used in order to obtain the cycle warranty. Cycle

credit is determined as follows: (Refer to Table B)

100 x

cycles 38

cyclesmin 5 of #

cycles 32

cyclesmin 10 of #

cycles 25

cyclesmin 15 of #

cycles 20

cyclesmin 30 of#

1credit cycle %



Float Credit – Float service is determined from the install date or six months after shipment, whichever occurs first. Table A will be used to

determine float credit.

Credit ($)=Original Net Price X



Life Warrantedof Months

Life Expired of Months

Example: A 40 month old DataSafe™ HX battery has been cycled as follows:

Qty. 3 cycles between 15 to 30 minutes

Qty. 5 cycles between 10 and 15 minutes

Qty. 0 cycles between 5 and 10 minutes

Qty. 5 cycles between 0 and 5 minutes



credit 52%100 x .481.00

1.00credit Cycle 



credit 67%100%x

120

1creditFloat 

Result = Cycle Credit of 52% applies

EXCLUSIONS AND LIMITATIONS

1. The purchaser (user) shall give freshening charges to the battery a minimum of every three (3) months for Lead-Antimony and every six (6) months for Lead-

Calcium after shipment from the factory and until final installation. Refer to the installation and maintenance instructions for maximum storage intervals.

2. At least once every twelve (12) months, purchaser (user) must take readings and record information per the EnerSys installation/maintenance instructions. These

records must be maintained for warranty claim purposes. If warranty records are not kept, the warranty shall be null and void.

3. Parallel strings should be limited to five (5) strings, except with an expressed written consent from EnerSys headquarters in Reading, PA.

4. This warranty applies only to the original United States and Canada domestic purchaser (user) and is non-transferable internationally, except with the expressed

written consent from EnerSys headquarters in Reading, PA.

5. This warranty does not cover physical damage due to the acts of nature or man which stress the battery beyond design limits and exert undesirable influence aside

from normal wear and tear.

6. EnerSys assumes no responsibility for any work accomplished or expenses incurred, except with the expressed written consent from EnerSys headquarters in

Reading, PA.

7. Movement of batteries from original point of installation shall immediately void this product warranty, except with the expressed written consent from EnerSys

headquarters in Reading, PA.

8. Any storage shall be in a dry area having an average ambient temperature of 77ºF (25ºC), or less, and in accordance with EnerSys published

installation/maintenance instructions. Failure to follow EnerSys published guidelines and/or instructions may invalidate the product warranty, at the sole discretion

of EnerSys.

9. Manufacturer's acceptance of any items shipped to Manufacturer shall not be deemed an admission that the items so shipped are defective. Any items shipped

back to Manufacturer, shall in Manufacturer’s sole discretion, become Manufacturer’s sole property.

THIS LIMITED WARRANTY IS IN LIEU OF, AND MANUFACTURER DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, STATUTORY,

EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR

PURPOSE. MANUFACTURER’S EXCLUSIVE LIABILITY FOR BREACH OF WARRANTY SHALL BE TO REPLACE THE BATTERY WITHIN THE

EFFECTIVE WARRANTY PERIOD. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR ANY LOSS OR DAMAGES OF ANY OTHER KIND,

WHETHER DIRECT, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY, SPECIAL OR OTHERWISE. NOR SHALL MANUFACTURER BE LIABLE FOR

ANY REMOVAL OR INSTALLATION EXPENSE, OR THE LOSS OF TIME OR PROFITS.

Some countries and/or states do not allow limitation on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the

above limitations may not apply to you. This warranty gives you specific legal rights, which may vary from country to country and/or state to state.

_________________________________________________ _________________________________________________

Signed by Purchaser (user) Date

Signed by EnerSys Delaware Inc. Representative Date

_________________________________________________ _________________________________________________

Print Name, Title

EnerSys Order # ___________________________________