Datasheet

T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Management Card – User Manual 34003991EN/CA Page
88/121
7.2.3 Configuration of the JBUS/MODBUS communication parameters
◗ Use the cord supplied with the card.
◗ Connect the card to a computer equipped with a Hyper terminal type emulator. The serial link must be set at 9600 baud, 8 bits, no parity,
1 stop bit, and without flow control.
◗ Check that UPS power is on.
◗ Enter the MGEUPS or mgeups password (non modifiable).
Connect the RS232 link to a
terminal
(Microsoft Hyper terminal)