Datasheet

T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Management Card – User Manual 34003991EN/CA Page
27/121
4.2.1.2 "UPS status" zone: Essential information
◗ "Active sources": (available on parallel or modular UPS)
x UPS + y UPS redundant : x indicates the minimal number of UPS necessary to power the load,
y indicates the number of UPS in redundancy.
An alarm can be generated if the number of UPS in redundancy is less than a configurable threshold. See UPS modules section.
◗ "Power source": indicates whether the power comes from the utility or from the UPS battery
◗ "Output load level": indicates the power percentage used at UPS output
◗ "Output": indicates if the different UPS outputs are protected.
◗ "Master": indicates if the UPS main output is protected
◗ "Group1 and Group2": indicates if the controlled outlets (if available) are powered.
The various icons showing the status of the UPS outputs are:
• (green outlet)
• Outlet powered
• (red outlet)
• Outlet not powered or not protected
◗ Battery Information :
◗ "Battery load level": remaining battery charge (in percent).
The information is completed with the two following labels:
◗ “Charging” : if the utility power is present and the battery charge is in progress
◗ “Discharging”: if the UPS operates on battery.
◗ “Fault”: if the battery is faulty.
◗ "Remaining backup time": Estimation of the battery's maximum backup time remaining before UPS shutdown
◗ "Battery status": Result of the last automatic battery test carried out by the UPS
Possible values are:
– OK: the test was completed correctly
– NOK: the battery needs to be checked
– Deactivated: the automatic battery test is not validated on the UPS